Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Data Signal Circuit between Stereo Jack Adapter and Extension Module

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the extension module via this circuit.

WIRING DIAGRAM


E226627E10


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (EXTENSION MODULE - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the extension module connector.

  1. Disconnect the No. 1 stereo jack adapter assembly connector.



    E226480E76
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G44-2 (UDO-) - G81-2 (US1-)
    Always
    Below 1 Ω
    G44-3 (UDO+) - G81-3 (US1+)
    Always
    Below 1 Ω
    G44-5 (UJSS) - G81-5 (USG1)
    Always
    Below 1 Ω
    G44-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    G44-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    G44-5 (UJSS) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Extension Module)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)