Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM (for Radio Receiver Type)

AUDIO AND VISUAL SYSTEM (for Radio Receiver Type) > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

for Preparation Click here


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly through this circuit.
The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.

WIRING DIAGRAM


E244547E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
  1. Disconnect the No. 1 stereo jack adapter assembly and radio receiver assembly connectors.



    E211810E05
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G44-9 (AUXO) - G41-25 (ADPG)
    Always
    Below 1 Ω
    G44-6 (ARO) - G41-26 (VAR+)
    Always
    Below 1 Ω
    G44-7 (ALO) - G41-28 (VAL+)
    Always
    Below 1 Ω
    G44-8 (ASGN) - G41-27 (VA-)
    Always
    Below 1 Ω
    G44-10 (AGND) - G41-11 (AGND)
    Always
    Below 1 Ω
    G44-2 (UDO-) - G75-2 (US1-)
    Always
    Below 1 Ω
    G44-3 (UDO+) - G75-3 (US1+)
    Always
    Below 1 Ω
    G44-5 (UJSS) - G75-5 (USG1)
    Always
    Below 1 Ω
    G44-9 (AUXO) - Body ground
    Always
    10 kΩ or higher
    G44-6 (ARO) - Body ground
    Always
    10 kΩ or higher
    G44-7 (ALO) - Body ground
    Always
    10 kΩ or higher
    G44-8 (ASGN) - Body ground
    Always
    10 kΩ or higher
    G44-10 (AGND) - Body ground
    Always
    10 kΩ or higher
    G44-2 (UDO-) - Body ground
    Always
    10 kΩ or higher
    G44-3 (UDO+) - Body ground
    Always
    10 kΩ or higher
    G44-5 (UJSS) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio Receiver Assembly)
    *b
    Front view of wire harness connector
    (to No. 1 Stereo Jack Adapter Assembly)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)