Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR

AMBIENT TEMPERATURE SENSOR > INSPECTION

for Preparation Click here



1. INSPECT AMBIENT TEMPERATURE SENSOR (THERMISTOR ASSEMBLY)


    E214922E29
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A26-1 (+) - A26-2 (-)
    10°C (50°F)
    3.00 to 3.73 kΩ
    A26-1 (+) - A26-2 (-)
    15°C (59°F)
    2.45 to 2.88 kΩ
    A26-1 (+) - A26-2 (-)
    20°C (68°F)
    1.95 to 2.30 kΩ
    A26-1 (+) - A26-2 (-)
    25°C (77°F)
    1.60 to 1.80 kΩ
    A26-1 (+) - A26-2 (-)
    30°C (86°F)
    1.28 to 1.47 kΩ
    A26-1 (+) - A26-2 (-)
    35°C (95°F)
    1.00 to 1.22 kΩ
    A26-1 (+) - A26-2 (-)
    40°C (104°F)
    0.80 to 1.00 kΩ
    A26-1 (+) - A26-2 (-)
    45°C (113°F)
    0.65 to 0.85 kΩ
    A26-1 (+) - A26-2 (-)
    50°C (122°F)
    0.50 to 0.70 kΩ
    A26-1 (+) - A26-2 (-)
    55°C (131°F)
    0.44 to 0.60 kΩ
    A26-1 (+) - A26-2 (-)
    60°C (140°F)
    0.36 to 0.50 kΩ

    Text in Illustration 
    *a
    Component without harness connected
    (Ambient Temperature Sensor (Thermistor Assembly))
    *b
    Sensing Portion
    *c
    Resistance (kΩ)
    *d
    Allowable Range
    *e
    Temperature (°C (°F))

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the sensor connector.
    2. When measuring, the ambient temperature sensor (thermistor assembly) temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).

    1. If the result is not as specified, replace the ambient temperature sensor (thermistor assembly).