Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY

REAR COMBINATION LIGHT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT REAR COMBINATION LED LIGHT (STOP LIGHT)
  1. Disconnect the rear combination light socket and wire sub-assembly LH or RH.



    E241396E01
  1. Apply auxiliary battery voltage to the rear combination LED light and check that the light comes on.

    OK:
    Tester Connection
    Specified Condition
    Auxiliary battery positive (+) → Terminal 1
    Auxiliary battery negative (-) → Terminal 2
    The stop light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination LED Light (Stop Light))
    If the result is not as specified, replace the rear combination LED light (stop light).



2. INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH


    E150954E05
  1. Reconnect the rear combination light socket and wire sub-assembly LH.

  1. Apply auxiliary battery voltage to the rear combination light socket and wire sub-assembly LH and check that the light comes on.

    OK:
    Tester Connection
    Specified Condition
    Auxiliary battery positive (+) → Terminal 2 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The back-up light comes on
    Auxiliary battery positive (+) → Terminal 3 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The stop light comes on
    Auxiliary battery positive (+) → Terminal 4 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The taillight comes on
    Auxiliary battery positive (+) → Terminal 5 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The turn signal light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination Light Socket and Wire Sub-assembly LH)
    If the result is not as specified, replace the rear combination light socket and wire sub-assembly LH.



3. INSPECT REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY RH


    E150954E05
  1. Reconnect the rear combination light socket and wire sub-assembly RH.

  1. Apply auxiliary battery voltage to the rear combination light socket and wire sub-assembly RH and check that the light comes on.

    OK:
    Tester Connection
    Specified Condition
    Auxiliary battery positive (+) → Terminal 2 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The back-up light comes on
    Auxiliary battery positive (+) → Terminal 3 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The stop light comes on
    Auxiliary battery positive (+) → Terminal 4 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The taillight comes on
    Auxiliary battery positive (+) → Terminal 5 (B)
    Auxiliary battery negative (-) → Terminal 1 (E)
    The turn signal light comes on

    Text in Illustration 
    *a
    Component without harness connected
    (Rear Combination Light Socket and Wire Sub-assembly RH)
    If the result is not as specified, replace the rear combination light socket and wire sub-assembly RH.