Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    E223779E22
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Light Control Switch 
    Tester Connection
    Condition
    Specified Condition
    18 (T) - 12 (EL)
    Light control switch off
    10 kΩ or higher
    19 (A) - 12 (EL)*1
    10 kΩ or higher
    20 (H) - 12 (EL)
    10 kΩ or higher
    19 (A) - 12 (EL)*1
    Light control switch in DRL position
    Below 1 Ω
    18 (T) - 12 (EL)
    Light control switch in tail position
    Below 1 Ω
    18 (T) - 12 (EL)
    Light control switch in head position
    Below 1 Ω
    20 (H) - 12 (EL)
    Below 1 Ω
    Dimmer Switch 
    Tester Connection
    Condition
    Specified Condition
    11 (HU) - 12 (EL)
    Dimmer switch in high position
    Below 1 Ω
    11 (HU) - 12 (EL)
    Dimmer switch in high flasher position
    Below 1 Ω
    17 (HF) - 12 (EL)
    Below 1 Ω
    Turn Signal Switch 
    Tester Connection
    Condition
    Specified Condition
    13 (TR) - 12 (EL)
    Neutral
    10 kΩ or higher
    15 (TL) - 12 (EL)
    10 kΩ or higher
    13 (TR) - 12 (EL)
    Right turn
    Below 1 Ω
    15 (TL) - 12 (EL)
    Left turn
    Below 1 Ω
    Front Fog Light Switch*2 
    Tester Connection
    Condition
    Specified Condition
    3 (LFG) - 4 (BFG)
    Front fog light switch off
    10 kΩ or higher
    3 (LFG) - 4 (BFG)
    Front fog light switch on
    Below 1 Ω

    1. *1: Headlight dimmer switch w/ DRL OFF function
    2. *2: w/ Front Fog Light
    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Dimmer Switch Assembly)
    If the result is not as specified, replace the headlight dimmer switch assembly.