Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > INSPECTION

for Preparation Click here



1. INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E136319E30
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    4 (TB) - 1 (E)
    Hazard warning signal switch off
    10 kΩ or higher
    Hazard warning signal switch on
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Hazard Warning Signal Switch Assembly)
    If the result is not as specified, replace the hazard warning signal switch assembly.



  1. Illumination Inspection



      E136319E29
    1. Apply auxiliary battery voltage to the hazard warning signal switch assembly and check that the switch illuminates.

      OK:
      Tester Connection
      Specified Condition
      Auxiliary battery positive (+) → Terminal 3 (ILL+)
      Auxiliary battery negative (-) → Terminal 2 (ILL-)
      Illuminates

      Text in Illustration 
      *a
      Component without harness connected
      (Hazard Warning Signal Switch Assembly)
      If the result is not as specified, replace the hazard warning signal switch assembly.