Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Navigation Voice Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

This circuit is used when the voice guidance in the navigation system is on or the voice switch of the steering pad switch is pushed.
Using this circuit, the extension module sends signals to the radio and display receiver assembly.

WIRING DIAGRAM


E226628E15


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE)
  1. Disconnect the radio and display receiver assembly connector.

  1. Disconnect the extension module connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    b2-22 (VOL+) - b1-31 (VOL+)
    Always
    Below 1 Ω
    b2-23 (VOL-) - b1-30 (VOL-)
    Always
    Below 1 Ω
    b2-24 (SHD1) - b1-29 (SHD1)
    Always
    Below 1 Ω
    b2-22 (VOL+) - Body ground
    Always
    10 kΩ or higher
    b2-23 (VOL-) - Body ground
    Always
    10 kΩ or higher
    b2-24 (SHD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)