TRANSMISSION CONTROL CABLE > ADJUSTMENT |
| 1. INSPECT SHIFT LEVER POSITION |
While moving the shift lever from N to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.
Turn the ignition switch to on (READY) and check the following:
When the shift lever is moved to D, the vehicle moves forward.
When the shift lever is moved to R, the vehicle moves in reverse.
| 2. ADJUST SHIFT LEVER POSITION |
Apply the parking brake and move the shift lever to N.
Remove the rear console box assembly (Click here).
![]() |
Slide the adjuster case cover in the direction shown by the arrow.
| *1 | Adjuster Case |
| *2 | Adjuster Case Cover |
![]() |
Using a precision screwdriver, pull out the lock piece of the adjuster case.
| *1 | Adjuster Case |
| *2 | Lock Piece |
Using your fingers, gently pull the cable rod towards the rear of the vehicle to remove backlash.
![]() |
Push in the lock piece of the adjuster case to lock it.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Cable Rod |
![]() |
Move the adjuster case cover in the direction shown by the arrow.
| *1 | Adjuster Case |
| *2 | Lock Piece |
| *3 | Adjuster Case Cover |
Install the rear console box assembly (Click here).