Home › Drivetrain › P510 HYBRID TRANSMISSION / TRANSAXLE › SHIFT LEVER

SHIFT LEVER > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
  1. Move the shift lever to N.



    C251060
  1. Remove the shift lever knob sub-assembly.



2. REMOVE REAR CONSOLE BOX ASSEMBLY
(Click here)


3. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    C249908
  1. Disconnect the cable end from the shift lever assembly.



    C249910E01
  1. Rotate the nut approximately 180° in the direction shown in the illustration, and while holding the nut, disconnect the transmission control cable assembly from the shift lever plate.
    Text in Illustration 
    *1
    Nut
    *a
    Rotate Approximately 180°
    *b
    Disconnect

    NOTICE:
    Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



4. REMOVE SHIFT LEVER ASSEMBLY


    C249911
  1. Disconnect the 2 connectors from the shift lever assembly.

  1. Disengage the 2 clamps and separate the instrument panel wire from the shift lever assembly.



    C251061
  1. Remove the 4 bolts and shift lever assembly.