Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > DISASSEMBLY

for Preparation Click here



1. REMOVE QUICK HEATER ASSEMBLY (for Cold Area Specification Vehicles)


    E238256
  1. Remove the bolt and disconnect the earth wire.

  1. Disengage the clamp.



    E238255
  1. Disconnect the connector.

  1. Disengage the clamp.

  1. Remove the 2 screws and the quick heater assembly.



2. REMOVE HEATER BRACKET (for Cold Area Specification Vehicles)


    E238225
  1. Remove the bolt and heater bracket.



3. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY


    E238226
  1. Disengage the 3 claws and remove the clamp.



    E238227
  1. Remove the heater radiator unit sub-assembly from the air conditioner radiator assembly.



4. REMOVE COOLER EXPANSION VALVE


    E238228
  1. Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and cooler expansion valve.



5. REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E288000
  1. Remove the 6 screws.



    E238230
  1. Disengage the clamp and disconnect the connector from the lower heater case.

  1. Disengage the 4 claws and remove the lower heater case.



    E235037
  1. Remove the No. 1 cooler evaporator sub-assembly with the No. 1 cooler thermistor from the upper heater case.



    E235039
  1. Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.



6. REMOVE FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    E234954
  1. Remove the front evaporator temperature sensor (No. 1 cooler thermistor).



7. REMOVE DRAIN COOLER HOSE


    E238231
  1. Remove the drain cooler hose.



8. REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY


    E235040
  1. Remove the 2 screws and No. 2 air conditioning radiator damper servo sub-assembly.



9. REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY


    E235042
  1. Remove the 2 screws and No. 1 air conditioning radiator damper servo sub-assembly.