Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU AND RECEIVER
  1. Connect the connector to the tire pressure warning ECU and receiver.

  1. Engage the 2 tabs into the holes to temporarily install the tire pressure warning ECU and receiver.

  1. Install the bolt.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



2. INSTALL ROOF SIDE INNER GARNISH LH



3. REGISTRATION OF RECOGNITION CODE (w/o Smart Key System)
(Click here)


4. REGISTER TRANSMITTER ID
(Click here)


5. INSPECT TIRE PRESSURE WARNING SYSTEM
(Click here)


6. PERFORM INITIALIZATION
(Click here)