DTC C1516/16 Torque Sensor Zero Point Adjustment Incomplete |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1516/16 | Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration. | There is no malfunction if this DTC is not output again after clearing the DTCs and torque sensor calibration value, and performing zero point calibration. |
| 1.CHECK FOR DTC |
Clear the DTCs (step 1) (Click here).
Calibrate the torque sensor zero point (step 2) (Click here).
Check for DTCs (step 3) (Click here).
| Result | Proceed to |
| DTCs are still output after performing steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
|
| ||||
| A | |
| 2.REPLACE POWER STEERING ECU ASSEMBLY |
Replace the power steering ECU assembly (Click here).
| NEXT | |
| 3.CHECK FOR DTC |
Calibrate the torque sensor zero point (step 1) (Click here).
Check for DTCs (step 2) (Click here).
| Result | Proceed to |
| DTCs are still output after performing rotation angle sensor value initialization and steering zero point calibration 3 times. | A |
| Normal system code is output. | B |
|
| ||||
| A | ||
| ||