REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL REAR ENGINE OIL SEAL |
Apply MP grease to the lip of a new rear engine oil seal.
![]() |
Using SST and a hammer, tap in the rear engine oil seal until its surface is flush with the rear engine oil seal retainer edge.
| 2. INSTALL FLYWHEEL SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft damper sub-assembly.
Apply adhesive to the 2 or 3 end threads of 6 new bolts.
Temporarily install the flywheel sub-assembly with the 6 new bolts.
![]() |
Tighten the 6 bolts in the sequence shown in the illustration.
| 3. INSTALL TRANSMISSION INPUT DAMPER ASSEMBLY |
![]() |
Using SST, hold the crankshaft damper sub-assembly.
Temporarily install the transmission input damper assembly with 6 new bolts.
![]() |
Tighten the 6 bolts in the sequence shown in the illustration.
| 4. INSTALL HYBRID VEHICLE TRANSAXLE ASSEMBLY |