Home › Audio / Visual / Telematics › AUDIO / VIDEO › RADIO RECEIVER

RADIO RECEIVER > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



2. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)


    E244891
  1. Remove the 4 screws.



    E244892
  1. Disengage the 2 guides and pull the radio receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio receiver assembly with bracket.



3. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type)


    E237149
  1. Remove the 4 screws.



    E237150
  1. Disengage the 2 guides and pull the radio and display receiver assembly with bracket toward the rear of the vehicle.

  1. Disconnect each connector and remove the radio and display receiver assembly with bracket.



4. REMOVE NO. 1 RADIO RECEIVER BRACKET (w/ Navigation System)


    E237153
  1. Remove the 3 screws and No. 1 radio receiver bracket.



5. REMOVE NO. 2 RADIO RECEIVER BRACKET (w/ Navigation System)


    E237154
  1. Remove the 3 screws and No. 2 radio receiver bracket.



6. REMOVE EXTENSION MODULE (w/ Navigation System)


    E237155
  1. Disconnect the 3 connectors to remove the navigation wire.



    E237156
  1. Disconnect the connector to remove the extension module.



7. REMOVE NO. 1 RADIO BRACKET


    E237151
  1. Remove the 3 screws and No. 1 radio bracket.



8. REMOVE NO. 2 RADIO BRACKET


    E237152
  1. Remove the 3 screws and No. 2 radio bracket.



9. REMOVE RADIO RECEIVER ASSEMBLY (for Radio Receiver Type)


10. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)