DTC B2311 Power Window Motor Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2311 |
|
|
| 1.PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER DOOR WINDOW MOTOR) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / D-Door Motor / Active Test.
Perform the Active Test according to the display on the Techstream.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Power Window | Power window | OFF / UP / DOWN | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION (DRIVER DOOR WINDOW) |
Initialize the power window regulator motor assembly LH (for driver door) (Click here).
| NEXT | |
| 3.CHECK POWER WINDOW CONTROL SYSTEM (DRIVER DOOR WINDOW) |
Check that the driver door power window operates normally by opening and closing the window (Click here).
|
| ||||
| OK | |
| 4.CHECK WHETHER PARTS HAVE BEEN INSTALLED CORRECTLY |
Check that the power window components are installed correctly.
|
| ||||
| OK | |
| 5.CHECK DTC OUTPUT |
Turn the ignition switch off.
Wait for at least 10 seconds, and then turn the ignition switch to ON (IG).
Check for DTCs (Click here).
|
| ||||
| OK | ||
| ||