DTC P0ADB-227 Hybrid Battery Positive Contactor Control Circuit Low |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| P0ADB | 227 | Short to GND in the SMRB circuit Primary circuit of SMR (+) is malfunctioning. (2 trip detection logic) |
|
| DTC No. | Data List |
| P0ADB-227 |
|
| 1.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND) |
Disconnect connector G57 from the power management control ECU.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| G57-4 (SMRB) - Body ground | Ignition switch off | 25.0 to 59.0 Ω |
| *a | Rear view of wire harness connector (to Power Management Control ECU) |
Connect the power management control ECU connector.
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - HYBRID BATTERY JUNCTION BLOCK ASSEMBLY) |
Check that the service plug grip is not installed.
Remove the No. 1 hybrid vehicle battery cover panel LH .
Disconnect connector M40 from the hybrid battery junction block assembly.
Disconnect connector G57 from the power management control ECU.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| G57-4 (SMRB) and M40-1 (SMRB) - Body ground and other terminals | Ignition switch off | 10 kΩ or higher |
| *a | Rear view of wire harness connector (to Power Management Control ECU) |
| *b | Rear view of wire harness connector (to Hybrid Battery Junction Block Assembly) |
Connect the power management control ECU connector.
Connect the hybrid battery junction block assembly connector.
Install the No. 1 hybrid vehicle battery cover panel LH.
|
| ||||
| OK | ||
| ||