REAR DOOR > ADJUSTMENT |

| *1 | Centering Bolt |
| *2 | Standard Bolt |
| 1. INSPECT REAR DOOR |
Check that the clearance measurements of areas "a" through "m" are within each standard range.

| Area | Measurement | Area | Measurement |
| a | 3.2 to 6.2 mm (0.126 to 0.244 in.) | b | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| c | 3.2 to 6.2 mm (0.126 to 0.244 in.) | d | 2.1 to 5.1 mm (0.0827 to 0.167 in.) |
| e | 3.2 to 6.2 mm (0.126 to 0.244 in.) | f | 2.3 to 5.3 mm (0.0906 to 0.209 in.) |
| g | 2.7 to 5.7 mm (0.106 to 0.224 in.) | h | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| i | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | j | 2.7 to 5.7 mm (0.106 to 0.224 in.) |
| k | 4.2 to 7.2 mm (0.165 to 0.283 in.) | l | 3.2 to 6.2 mm (0.126 to 0.244 in.) |
| m | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | - | - |
| 2. ADJUST REAR DOOR |
![]() |
Using SST, loosen the hinge bolts on the vehicle body and adjust the door position.
Tighten the hinge bolts on the vehicle body after the adjustment.
Loosen the hinge bolts on the door and adjust the door position.
Tighten the hinge bolts on the door after adjustment.
![]() |
Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.
Using a brass bar and a hammer, hit the striker to adjust its position.
Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.