NAVIGATION SYSTEM > Radio Receiver Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - AUXILIARY BATTERY, BODY GROUND) |
Disconnect the radio and display receiver assembly connector.
Measure the resistance according to the value(s) in the table below .
| Tester Connection | Condition | Specified Condition |
| G76-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G76-4 (+B1) - G76-7 (GND1) | Ignition switch off | 11 to 14 V |
| G76-3 (ACC1) - G76-7 (GND1) | Ignition switch ACC | 11 to 14 V |
| G78-1 (IG) - G76-7 (GND1) | Ignition switch ON (IG) | 11 to 14 V |
|
| ||||
| OK | ||
| ||