Home › Engine / Hybrid System › 1NZ-FXE INTAKE / EXHAUST › INTAKE MANIFOLD

INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
(Click here)


2. REMOVE NO. 2 EGR PIPE


    A268229
  1. Disconnect the wire harness clamp.

  1. Disengage the clamp and disconnect the No. 2 water by-pass hose.

  1. Remove the 2 bolts and 2 nuts.

  1. Remove the No. 2 EGR pipe and 2 gaskets.



3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY
  1. Remove the air cleaner filter element sub-assembly.



    A267683
  1. Remove the 2 bolts, grommet and air cleaner case sub-assembly.



4. REMOVE MANIFOLD ABSOLUTE PRESSURE SENSOR


    A267675
  1. Disconnect the connector.

  1. Remove the bolt and manifold absolute pressure sensor.



5. REMOVE INTAKE MANIFOLD STAY


    A268286
  1. Remove the 2 bolts and intake manifold stay.



6. REMOVE INTAKE MANIFOLD


    A267685
  1. Disconnect the 4 wire harness clamps and water by-pass hose.



    A267684
  1. Disconnect the fuel vapor feed hose and ventilation hose.



    A268526
  1. Remove the 3 bolts, 2 nuts and intake manifold.



    A268531
  1. Remove the ventilation hose.



    A268529
  1. Remove the bolt and intake manifold insulator.



    A268530
  1. Remove the No. 1 intake manifold to head gasket.