Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER

REAR BUMPER > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 FLOOR UNDER COVER


    B297213
  1. Remove the 5 clips and No. 1 floor under cover.



2. REMOVE REAR BUMPER CUSHION


    B307352
  1. Using a T30 "TORX" socket wrench, remove the 2 rear bumper cushions.



3. REMOVE REAR BUMPER ASSEMBLY


    B256853E01
  1. Apply protective tape, as shown in the illustration.
    Text in Illustration 
    V100155
    Protective Tape

    HINT:
    1. As shown in illustration A, while inserting protective tape into the gap between the rear bumper assembly and the rear combination light assembly, adhere the tape to the upper surface of the rear bumper assembly.
    2. As shown in illustration B, while inserting protective tape into the gap between the rear bumper assembly and the rear combination light assembly, adhere the tape to the rear combination light assembly to cover the area from the tip to the far part of the inner side.



    B307354
  1. Remove the 6 clips.



    B307355
  1. Disengage the 5 claws as shown in the illustration.

    HINT:
    Use the same procedure for the RH side and LH side.



    B307356
  1. Disengage the 2 claws and remove the rear bumper assembly as shown in the illustration.