Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/ Smart Key System)


    B142645E08
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Opener Switch assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (L) - 2 (E)
    Lock switch pushed
    Below 1 Ω
    Lock switch and open switch not pushed
    10 kΩ or higher
    3 (UL) - 2 (E)
    Open switch pushed
    Below 1 Ω
    Lock switch and open switch not pushed
    10 kΩ or higher

    1. If the result is not as specified, replace the back door opener switch assembly.



2. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY (w/o Smart Key System)


    B142645E06
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *a
    Component without harness connected
    (Back Door Opener Switch assembly)

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    2 (E) - 3 (UL)
    Open switch pushed
    Below 1 Ω
    Open switch not pushed
    10 kΩ or higher

    1. If the result is not as specified, replace the back door opener switch assembly.