Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Front Door)

POWER WINDOW REGULATOR MOTOR (for Front Door) > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH


    B203475E23
  1. Apply positive (+) auxiliary battery voltage to connector terminal 2 (B).

    NOTICE:
    Do not apply positive (+) auxiliary battery voltage to any terminals other than terminal 2 (B) to avoid damaging the pulse sensor inside the motor.

  1. Connect a negative (-) auxiliary battery to connector terminals 1 (GND) and 7 (DOWN) or 10 (UP).

  1. Check that the motor gear rotates smoothly as follows:

    OK:

    Measurement Condition
    Specified Condition
    1. Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more.
    2. With terminals 2 (B) and 1 (GND) connected, connect a negative (-) auxiliary battery lead to terminal 10 (UP).
    3. Disconnect and reconnect the negative (-) auxiliary battery lead for terminal 10 (UP) within 1 second.
    Motor gear rotates clockwise
    1. Connect a positive (+) auxiliary battery lead to terminal 2 (B), connect a negative (-) auxiliary battery lead to terminal 1 (GND), and keep them connected for 3 seconds or more.
    2. With terminals 2 (B) and 1 (GND) connected, connect a negative (-) auxiliary battery lead to terminal 7 (DOWN).
    3. Disconnect and reconnect the negative (-) auxiliary battery lead for terminal 7 (DOWN) within 1 second.
    Motor gear rotates counterclockwise

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Motor Assembly LH)
    *b
    Counterclockwise
    *c
    Clockwise
    1. If the result is not as specified, replace the power window regulator motor assembly LH.

    NOTICE:
    Reset the power window regulator motor (initialize the pulse sensor) after installing the power window regulator motor and regulator assembly.



2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH


    B127536E07
  1. Apply auxiliary battery voltage to the motor connector according to the table below.

    NOTICE:
    Do not apply auxiliary battery voltage to any terminals except terminals 1 and 2.

    Standard:
    Measurement Condition
    Specified Condition
    Auxiliary battery positive (+) → Terminal 1
    Auxiliary battery negative (-) → Terminal 2
    Motor gear rotates clockwise
    Auxiliary battery positive (+) → Terminal 2
    Auxiliary battery negative (-) → Terminal 1
    Motor gear rotates counterclockwise

    Text in Illustration 
    *a
    Component without harness connected
    (Power Window Regulator Motor Assembly RH)
    *b
    Motor Gear
    *c
    Clockwise
    *d
    Counterclockwise
    If the result is not as specified, replace the power window regulator motor assembly RH.