Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR

COMPRESSOR > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM
  1. Start the hybrid system.

  1. Operate the cooler compressor under the conditions show below:
    Item
    Condition
    Engine Speed
    Idling
    Operating Time
    3 minutes or more
    A/C Switch Status
    ON
    Blower Switch Status
    HI
    Set Temperature
    MAX COOL
    This causes most of the compressor oil from the various components of the A/C system to collect in the A/C compressor.

    HINT:
    It is not necessary to operate the cooler compressor if the A/C does not operate because of compressor lock, etc.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    HINT:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.



2. REMOVE SERVICE PLUG GRIP
(Click here)


3. CHECK TERMINAL VOLTAGE
  1. Remove the inverter terminal cover .

  1. Remove the inverter cover .

  1. Check the terminal voltage .

  1. Install the inverter cover .

  1. Install the inverter terminal cover .



4. REMOVE ENGINE UNDER COVER RH


5. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    E234973
  1. Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor with motor assembly.

  1. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



6. DISCONNECT SUCTION HOSE SUB-ASSEMBLY


    E234974
  1. Remove the bolt and disconnect the suction hose sub-assembly from the compressor with motor assembly.

  1. Remove the O-ring from the suction hose sub-assembly.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



7. REMOVE COMPRESSOR WITH MOTOR ASSEMBLY


    E234971E01
  1. Using a screwdriver, slide the green-colored lock of the connector <A> in the direction indicated by the arrow in the illustration to release it and disconnect the connector.
    Text in Illustration 
    *1
    Green-colored Lock

    CAUTION:
    Make sure to wear insulating gloves.

    NOTICE:
    Insulate the removed terminals and connector with insulating tape.

  1. Disconnect the connector <B>.



    E234975
  1. Remove the 3 bolts and the compressor with motor assembly.