Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › ROOF DRIP SIDE FINISH MOULDING

ROOF DRIP SIDE FINISH MOULDING > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE ROOF DRIP SIDE FINISH MOULDING


    B298014E01
  1. Apply protective tape as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B298015
  1. Disengage the 2 clips and remove the roof drip side finish moulding.

    NOTICE:
    1. Do not remove the clips.
    2. If any clip is damaged or falls out, replace it with a new one.