NAVIGATION SYSTEM > Sound Signal Circuit between Radio Receiver and Extension Module |

| 1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE) |
Disconnect the radio and display receiver assembly connector.
Disconnect the extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b3-2 (R+) - b1-13 (R+) | Always | Below 1 Ω |
| b3-3 (R-) - b1-12 (R-) | Always | Below 1 Ω |
| b3-4 (L+) - b1-15 (L+) | Always | Below 1 Ω |
| b3-5 (L-) - b1-14 (L-) | Always | Below 1 Ω |
| b3-1 (SHD3) - b1-28 (SHD3) | Always | Below 1 Ω |
| b3-2 (R+) - Body ground | Always | 10 kΩ or higher |
| b3-3 (R-) - Body ground | Always | 10 kΩ or higher |
| b3-4 (L+) - Body ground | Always | 10 kΩ or higher |
| b3-5 (L-) - Body ground | Always | 10 kΩ or higher |
| b3-1 (SHD3) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||