Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › MASS AIR FLOW METER

MASS AIR FLOW METER > INSPECTION

for Preparation Click here



1. INSPECT MASS AIR FLOW METER


    A190679E02
  1. Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.
    Text in Illustration 
    *1
    Platinum Hot Wire (Heater)

    Result:
    There is no foreign matter.



    A190680E02
  1. Measure the resistance according to the value(s) in the table below.
    Text in Illustration 
    *1
    Mass Air Flow Meter

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (THA) - 2 (E2)
    -20°C (-4°F)
    13.6 to 18.4 kΩ
    20°C (68°F)
    2.21 to 2.69 kΩ
    60°C (140°F)
    0.49 to 0.67 kΩ

    If the result is not as specified, replace the mass air flow meter.