Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B279A    Theft Deterrent System Communication Line High Fixation

for Preparation Click here


DESCRIPTION

When the communication line (IMI - EFIO) between the power management control ECU and transponder key ECU assembly is stuck on HI output, the power management control ECU stores this DTC.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279A
The communication line (IMI - EFIO) between the power management control ECU and transponder key ECU assembly is stuck on HI output (1 trip detection logic*).
  1. Harness or connector
  2. Transponder key ECU assembly
  3. Power management control ECU
Turn the ignition switch to ON and wait 6 seconds.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Hybrid control system cannot be started
Hybrid control system cannot be started

Related Data List and Active Test 
DTC Code
Data List and Active Test
B279A
-

WIRING DIAGRAM


B288680E07


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the transponder key ECU assembly, refer to the Registration (Click here).
  2. After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.CLEAR DTC
  1. Clear the DTCs (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    HINT:
    Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

    OK:
    DTC B279A is not output.



NG
Go to step 3
OK

USE SIMULATION METHOD TO CHECK (Click here)  

3.CHECK CONNECTION OF CONNECTOR
  1. Check that the connectors are properly connected to the power management control ECU and transponder key ECU assembly.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - POWER MANAGEMENT CONTROL ECU AND BODY GROUND)
  1. Disconnect the G46 transponder key ECU assembly connector.

  1. Disconnect the G58 power management control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G46-13 (EFIO) - G58-21 (IMI)
    Always
    Below 1 Ω
    G46-13 (EFIO) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE TRANSPONDER KEY ECU ASSEMBLY
  1. Replace the transponder key ECU assembly with a new one (Click here).


NEXT


6.REGISTER KEY
  1. Register the key (Click here).


NEXT


7.REGISTER ECU COMMUNICATION ID
  1. Register the ECU communication ID (Click here).


NEXT


8.CHECK WHETHER HYBRID CONTROL SYSTEM STARTS
  1. Check that the hybrid control system starts with the key.

    OK:
    Hybrid control system starts normally.



NG
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
OK

END (TRANSPONDER KEY ECU ASSEMBLY WAS DEFECTIVE)