Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM (w/o Smart Key System)

DTC    B279C    Theft Deterrent System Presence Detection

for Preparation Click here


DESCRIPTION

This code is stored when a power management control ECU that is incompatible with the engine immobiliser system is installed to the vehicle.

DTC Code
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C
A power management control ECU that is incompatible with the engine immobiliser system is installed (1 trip detection logic*).
Power management control ECU
Check for DTCs.
  1. *: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Operation when Malfunction Detected
Hybrid control system cannot be started
-

Related Data List and Active Test 
DTC Code
Data List and Active Test
B279C
-

INSPECTION PROCEDURE

NOTICE:
  1. Before replacing the power management control ECU, refer to Registration (Click here).
  2. After performing repair, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.

1.REPLACE CURRENT POWER MANAGEMENT CONTROL ECU WITH PROPER POWER MANAGEMENT CONTROL ECU
  1. Replace the current power management control ECU with the proper power management control ECU (Click here).


NEXT

END