Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > PRECAUTION

for Preparation Click here



NOTICE:
When disconnecting the cable from the negative (-) auxiliary battery terminal, initialize the following system after the cable is reconnected.

System Name
See Procedure
Power Door Lock Control System
Click here


1.IGNITION SWITCH EXPRESSIONS
  1. The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

    Expression
    Ignition Switch (Position)
    Power Switch (Condition)
    Ignition Switch off
    LOCK
    Off (Lock)
    Ignition Switch ACC
    ACC
    On (ACC)
    Ignition Switch ON (IG)
    ON (IG)
    On (IG)
    Ignition Switch ON (READY)
    ON (READY)
    On (READY)


2.PRECAUTIONS WHEN USING TECHSTREAM
  1. When using the Techstream to troubleshoot with the ignition switch off:
    Connect the Techstream to the DLC3, and turn the courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.