LIN COMMUNICATION SYSTEM > DATA LIST / ACTIVE TEST |
| DATA LIST |
Connect the Techstream to the DLC3.
Turn the ignition switch ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Communication D-Door Motor | Connection status between power window regulator motor assembly (for driver door) and main body ECU (multiplex network body ECU)/OK or STOP | OK: Connected STOP: Not Connected | DTC is output if an error occurs in LIN communication. |
| Communication Slide Roof* | Connection status between sliding roof ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU)/OK or STOP | OK: Connected STOP: Not Connected | DTC is output if an error occurs in LIN communication. |