Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR OPENER SWITCH

BACK DOOR OPENER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
  1. Install the back door opener switch.

    HINT:
    Make sure the arrows on the back door opener switch and the back door garnish are pointing in the same direction.



2. INSTALL LUGGAGE OUTSIDE COMPARTMENT DOOR GARNISH SUB-ASSEMBLY
  1. Install 5 new gaskets to the luggage compartment door outside garnish sub-assembly.

  1. Install the back door opener switch assembly .

  1. Engage the clip.

  1. Install the luggage compartment door outside garnish sub-assembly with the 5 nuts.

    Torque:
    4.9 N*m{ 50 kgf*cm , 43 in.*lbf }

  1. Connect the connector.



3. INSTALL BACK DOOR TRIM COVER


    B297007
  1. Engage the 6 clips to install the back door trim cover.



4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    B297006
  1. Install the back door trim assembly with the 10 clips.