REAR WIPER MOTOR > INSTALLATION |
| 1. INSTALL REAR WIPER MOTOR GROMMET |
![]() |
Apply MP grease to the entire surface of the rear wiper motor grommet lip.
| *a | Rear Wiper Motor Grommet Lip |
Install the rear wiper motor grommet.
| 2. INSTALL REAR WIPER MOTOR ASSEMBLY |
Insert the shaft of rear wiper motor assembly to the rear wiper motor grommet.
![]() |
Install the rear wiper motor assembly with the 3 bolts.
Connect the connector.
| 3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY |
When reusing the rear wiper arm and blade assembly:
![]() |
Clean the wiper arm serrations.
| *1 | Wiper Arm Serrations |
| *2 | Wiper Pivot Serrations |
When reusing the windshield wiper link assembly:
Clean the wiper pivot serrations with a wire brush.
Operate the wiper and stop the windshield wiper motor at the automatic stop position.
Temporarily install the rear wiper arm and blade assembly with the nut.
![]() |
Install the rear wiper arm and blade assembly with the nut to the position as shown in the illustration.
| *1 | Dot (Print) |
| Area | Measurement |
| A | 10.0mm (0.394 in.) |
Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.
Lift the wiper arm twice after the wiper stops and check the wiper set position.
| 4. INSTALL REAR WIPER ARM HEAD CAP |
![]() |
Engage the 2 guides to the rear wiper arm and blade assembly.
Engage the 2 claws to install the rear wiper arm head cap as shown in the illustration.
| 5. INSTALL BACK DOOR TRIM COVER |
![]() |
Engage the 6 clips to install the back door trim cover.
| 6. INSTALL BACK DOOR TRIM BOARD ASSEMBLY |
![]() |
Install the back door trim assembly with the 10 clips.