Home › Vehicle Interior › SEAT › FRONT SEATBACK HEATER

FRONT SEATBACK HEATER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEATBACK HEATER ASSEMBLY
  1. Install the front seatback heater assembly to the separate type front seatback cover with 12 new tag pins.



2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER


    B281074
  1. Using hog ring pliers, install the separate type front seatback cover to the separate type front seatback pad with 6 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.



3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
  1. Temporarily install the separate type front seatback cover with pad.

  1. Engage the 4 claws to install the 2 front seat headrest supports.

  1. Install the 3 brackets with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    CAUTION:
    1. For vehicles with a front seat airbag assembly, the separate type front seatback cover must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.
    2. Make sure that the strap is not twisted after installing the nut.
    3. Install the bracket securely.



    B301370
  1. Turn back the separate type front seatback cover.



    B301368
  1. Using hog ring pliers, install 3 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.



    B311802
  1. Using hog ring pliers, install 5 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seatback cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.



4. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
  1. Engage the 2 claws and 4 guides to install the front seat inner cushion shield.



5. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
  1. Engage the 3 claws and 6 guides to install the front seat inner cushion shield.



6. INSTALL FRONT SEAT CUSHION SHIELD
  1. Engage the 2 claws, 4 guides and clip to install the front seat cushion shield.

  1. Install the screw.



7. CONNECT SEPARATE TYPE FRONT SEATBACK COVER
  1. Connect the rubber band of the separate type front seatback cover.



8. INSTALL VERTICAL ADJUSTING HANDLE (for Driver Side)
  1. Install the vertical adjusting handle with the screw.



9. INSTALL RECLINING ADJUSTER RELEASE HANDLE
  1. Engage the claw to install the reclining adjuster release handle.



10. INSTALL FRONT SEAT ASSEMBLY
(Click here)