Home › Vehicle Interior › SEAT › FRONT SEAT CUSHION HEATER

FRONT SEAT CUSHION HEATER > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY
  1. Install the front seat cushion heater assembly to the separate type front seat cushion cover with 12 new tag pins.



2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER


    B301356
  1. Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 18 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seat cushion cover.



    B301354
  1. Using hog ring pliers, install 2 new hog rings.

    NOTICE:
    1. Be careful not to damage the separate type front seat cushion cover.
    2. Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seat cushion cover.



3. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
  1. Temporarily install the separate type front seat cushion cover with pad.

  1. Engage each hook.

  1. Engage the clamp.

  1. Connect the connector.

  1. for Driver Side:

    1. Engage the 4 clamps to install the seat heater wire harness.

  1. for Front Passenger Side:

    1. Engage the claw and 3 clamps to install the seat heater wire harness.



4. CONNECT FRONT SEAT AIRBAG ASSEMBLY
  1. for Driver Side:

    1. Engage the claw and 6 clamps to install the front seat airbag assembly wire harness.

  1. for Front Passenger Side:

    1. Engage the claw and 3 clamps to install the front seat airbag assembly wire harness.

  1. Engage the fastener to secure the front seat airbag assembly wire harness.



5. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Driver Side)
  1. Engage the 2 claws and 4 guides to install the front seat inner cushion shield.



6. INSTALL FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)
  1. Engage the 3 claws and 6 guides to install the front seat inner cushion shield.



7. INSTALL FRONT SEAT LOWER CUSHION SHIELD (for Driver Side)
  1. Engage the 2 claws to install the front seat lower cushion shield.



8. INSTALL FRONT SEAT CUSHION SHIELD
  1. Engage the 2 claws, 4 guides and clip to install the front seat cushion shield.

  1. Install the screw.



9. CONNECT SEPARATE TYPE FRONT SEATBACK COVER
  1. Connect the rubber band of the separate type front seatback cover.



10. INSTALL VERTICAL ADJUSTING HANDLE (for Driver Side)
  1. Install the vertical adjusting handle with the screw.



11. INSTALL RECLINING ADJUSTER RELEASE HANDLE
  1. Engage the claw to install the reclining adjuster release handle.



12. INSTALL FRONT SEAT ASSEMBLY
(Click here)