Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 IGNITION COIL


    A267419
  1. Disconnect the 4 No. 1 ignition coil connectors.

  1. Remove the 4 bolts and 4 No. 1 ignition coils.

    NOTICE:
    When removing each ignition coil, do not damage the plug cap on the engine head cover opening or the upper edge of the spark plug tube.



2. REMOVE SPARK PLUG


    A267420
  1. Using a 16 mm spark plug wrench, remove the 4 spark plugs.