Home › Engine / Hybrid System › 1NZ-FXE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR

ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL

for Preparation Click here



1. DRAIN COOLANT (for Engine)

NOTICE:
Do not remove the water filler cap sub-assembly, engine drain cock plug or radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug.



  1. Remove the water filler cap sub-assembly and drain the coolant.


    A267952E01


    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug
    *3
    Engine Drain Cock Plug
    *4
    Water Filler

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A267960
  1. Remove the stop ring.



    A268695E01
  1. Connect the hose to the engine drain cock plug.
    Text in Illustration 
    *1
    Hose

  1. Pull out the engine drain cock plug and drain the coolant.



2. REMOVE INVERTER WITH CONVERTER ASSEMBLY
(Click here).


3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    A267835
  1. Disconnect the wire harness.



    A267834
  1. Disconnect the engine coolant temperature sensor connector.



    A267836E01
  1. Using a union nut wrench 19 mm, remove the engine coolant temperature sensor.
    Text in Illustration 
    *a
    Union Nut Wrench
    *b
    Gasket

  1. Remove the gasket from the engine coolant temperature sensor.