POWER MIRROR CONTROL SYSTEM > OPERATION CHECK |
| CHECK REMOTE CONTROL MIRROR FUNCTION |
Turn the ignition switch to ON (IG).
With the mirror select switch set to L, check that the outer mirror LH surface moves up, down, left and right normally.
With the mirror select switch set to R, check that the outer mirror RH surface moves up, down, left and right normally.
| CHECK MIRROR HEATER FUNCTION (w/ Mirror Heater) |
Turn the ignition switch to ON (IG).
Check that pressing the mirror heater switch (rear window defogger switch) illuminates the indicator and warms the mirror surface.
Check that after approximately 15 minutes, the indicator light turns off and the mirror heater deactivates.