Home › Steering › STEERING COLUMN › STEERING WHEEL

STEERING WHEEL > REMOVAL

for Preparation Click here


NOTICE:
  1. Do not replace the spiral cable with sensor sub-assembly with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
  2. Do not rotate the spiral cable with sensor sub-assembly without the steering wheel with the negative (-) auxiliary battery cable connected and the ignition switch on (IG).
  3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
  4. Do not remove the steering sensor from the spiral cable.



1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


2. REMOVE HORN BUTTON ASSEMBLY
(Click here)


3. REMOVE STEERING WHEEL ASSEMBLY


    C252595E01
  1. Remove the steering wheel assembly set nut.
    Text in Illustration 
    *a
    Matchmark

  1. Put matchmarks on the steering wheel assembly and steering main shaft.

  1. Disconnect the connectors from the spiral cable.



    C252596E01
  1. Using SST, remove the steering wheel assembly.
    Text in Illustration 
    *a
    Turn
    *b
    Hold

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05070)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (09953-05020) before use.



4. REMOVE STEERING PAD SWITCH ASSEMBLY
  1. Disconnect the steering pad switch connector from the spiral cable.



    C206250
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the steering pad switch assembly (RH side) from the steering wheel sub-assembly.



    C206251
  1. Remove the 2 screws.

  1. Disengage the 2 claws to remove the steering pad switch assembly (LH side) from the steering wheel sub-assembly.



5. REMOVE CRUISE CONTROL SWITCH (w/ Cruise Control System)


    E244460
  1. Disconnect the connector.



    E244461
  1. Remove the 2 screws and cruise control switch.



6. REMOVE CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)


7. REMOVE LOWER STEERING WHEEL BOSS COVER


    C206252
  1. Disengage the 2 pins and 4 claws to remove the lower steering wheel boss cover from the steering wheel sub-assembly.