Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER

REAR DOOR SPEAKER > INSTALLATION

for Preparation Click here



1. INSTALL REAR SPEAKER ASSEMBLY


  1. Using an air riveter or a hand riveter, install the rear speaker assembly with 3 new rivets.


    E244889E01


    Text in Illustration 
    *1
    Riveter
    *2
    Mandrel
    *a
    INCORRECT
    *b
    CORRECT

    NOTICE:
    1. Do not touch the cone part of the speaker.
    2. Do not pry on the rivets with the riveter, as this will cause damage to the riveter and mandrel.
    3. Confirm that the rivets are seated properly against the speaker.
    4. Do not tilt the riveter when installing the rivets to the speaker.
    5. Do not leave any clearance between the rivet heads and speaker.
    6. Do not leave any clearance between the speaker and door. Firmly hold the 2 items together while installing the rivets.

    HINT:
    1. Install the rivets in the order shown in the illustration.
    2. If the rivet cannot be cut, pull it once and cut it.

  1. Connect the connector.



2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY


    B307178E01
  1. Connect the rear door lock remote control cable assembly and rear door inside locking cable assembly to the rear door inside handle.
    Text in Illustration 
    *1
    Rear Door Inside Locking Cable Assembly
    *2
    Rear Door Lock Remote Control Cable Assembly



    B308235
  1. Install the clip.



    B307182
  1. Engage the 7 clips.



    B307134
  1. Install the rear door trim board sub-assembly with the 3 screws.



    B307179
  1. Engage the claw and close the cover.



3. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
  1. Connect the connector.



    B307129
  1. Engage the 3guides and 8 claws to install the rear power window regulator switch assembly with rear door armrest base panel.



4. INSTALL REAR DOOR FRAME GARNISH


    B307128
  1. Engage the guide.

  1. Engage the 2 clips and 3 claws to install the rear door frame garnish.