Home › Vehicle Interior › INTERIOR PANELS / TRIM › ROOF HEADLINING

ROOF HEADLINING > DISASSEMBLY

for Preparation Click here


NOTICE:
The pads, spacers and roof headlining cannot be reused as they will be damaged when the pads and spacers are removed from the roof headlining assembly.



1. REMOVE ROOF HEADLINING RETAINER COVER (w/o Sliding Roof)


    E244886
  1. Disconnect the connector.



    E237172
  1. Disengage the 4 claws and remove the roof headlining retainer cover.



2. REMOVE AMPLIFIER MICROPHONE ASSEMBLY (w/o Sliding Roof)


    E237173
  1. Disengage the 2 claws and remove the amplifier microphone assembly from the roof headlining holder cover.



3. REMOVE UPPER SHOULDER BELT ANCHOR COVER


    B297740
  1. Disengage the 4 claws and remove the seat belt anchor cover.

  1. Remove the rear seat shoulder belt cover RH.



4. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Peel back the tape used to secure the antenna cord only to the extent that allows removal of the No. 2 antenna cord sub-assembly.

    HINT:
    Tape is not available as a supply part. Try to leave as much tape as possible on the roof headlining so that the tape can be reused.



  1. Disengage each clamp and remove the No. 2 antenna cord sub-assembly from the roof headlining.


    E237161E01


    Text in Illustration 
    *A
    w/o Sliding Roof
    *B
    w/ Sliding Roof
    *1
    Tape
    -
    -
    *a
    Front
    -
    -



5. REMOVE NO. 1 ROOF WIRE (w/o Sliding Roof)


    B300773
  1. Remove the adhesive tape from the roof headlining.

  1. Remove the No. 1 roof wire from the roof headlining.



6. REMOVE NO. 1 ROOF WIRE (w/ Sliding Roof)


    B300774
  1. Remove the adhesive tape from the roof headlining.

  1. Disengage the 3 clamps.

  1. Remove the No. 1 roof wire from the roof headlining.