Home › Vehicle Interior › DOOR LOCK › TRANSMITTER BATTERY (w/o Smart Key System)

TRANSMITTER BATTERY (w/o Smart Key System) > REPLACEMENT

for Preparation Click here



1. REMOVE TRANSMITTER HOUSING COVER


    B279140E01
  1. Using a precision screwdriver with its tip wrapped in protective tape, pry open the transmitter housing cover.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Do not forcibly pry the cover.

    HINT:
    1. Tape the screwdriver tip before use.
    2. Open the cover as shown in the illustration so as not to drop the button.



2. REMOVE DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    B279142E01
  1. Using a precision screwdriver with its tip wrapped in protective tape, remove the door control transmitter module set sub-assembly from the transmitter housing case.
    Text in Illustration 
    *1
    Protective Tape

    NOTICE:
    Handle each part with care as they are delicate electrical parts.

    HINT:
    1. Tape the screwdriver tip before use.
    2. When removing the module, please attention to drop the button.



3. REMOVE TRANSMITTER BATTERY


    B279144
  1. Twist the coin in the direction of the arrow in the illustration, and remove the transmitter battery cover.



    B279146
  1. Remove the transmitter battery (lithium battery: CR2016).

    NOTICE:
    1. Do not push the terminals with your finger.
    2. Do not forcibly pry up the transmitter battery. The terminals may be damaged.
    3. Do not touch the transmitter battery with wet hands. Water may cause rust.
    4. Do not touch or move any components inside the transmitter. It may interfere with proper operation.
    5. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.



4. INSTALL TRANSMITTER BATTERY


    B279147
  1. Install a transmitter battery (lithium battery: CR2016) with the positive (+) side facing upward, as shown in the illustration.

    NOTICE:
    1. Be careful not to bend the transmitter battery electrode during insertion.
    2. Keep the transmitter cover interior free of dust and oil.
    3. When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.



    B279145
  1. Install the cover.



5. INSTALL DOOR CONTROL TRANSMITTER MODULE SET SUB-ASSEMBLY


    B279143
  1. Install the door control transmitter module set sub-assembly into the transmitter housing case.



6. INSTALL TRANSMITTER HOUSING COVER


    B279141
  1. Install the transmitter housing cover to the transmitter housing case.