AIR CONDITIONING PRESSURE SENSOR > REMOVAL |
| 1. RECOVER REFRIGERANT FROM AIR CONDITIONING SYSTEM |
Start the hybrid system.
Operate the cooler compressor under the conditions show below:
| Item | Condition |
| Engine Speed | Idling |
| Operating Time | 3 minutes or more |
| A/C Switch Status | ON |
| Blower Switch Status | HI |
| Set Temperature | MAX COOL |
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
| 2. REMOVE AIR CONDITIONER PRESSURE SENSOR |
![]() |
Disconnect the connector.
![]() |
Using a deep socket wrench 27 mm, remove the air conditioner pressure sensor.
| *a | Turn |
| *b | Hold |