Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER RUBBER

REAR WIPER RUBBER > REPLACEMENT

for Preparation Click here



1. REMOVE REAR WIPER BLADE


    E237501
  1. Raise the rear wiper blade to the position where the claw detaches with a click sound as shown in the illustration.

    NOTICE:
    Be careful not to damage the claw.



    E237502
  1. Pull the rear wiper blade straight toward the left side of the vehicle to remove it from the wiper arm.

    NOTICE:
    Do not lower the wiper arm with the wiper blade removed. The arm tip may damage the back door glass surface.



2. REMOVE REAR WIPER RUBBER


  1. Lift and pull the end of the rear wiper rubber protrusion from the blade stopper as shown in the illustration.


    E237504

    NOTICE:
    Do not forcibly pull out the wiper rubber. The backing plates may be deformed or the blade claws may be damaged.

    HINT:
    Lightly pushing the rubber in the middle will allow it to be removed more easily.



    E125273
  1. Remove the rear wiper rubber with the rear wiper rubber backing plates from the rear wiper blade.



    E237505
  1. Remove the 2 rear wiper rubber backing plates from the wiper rubber.



3. INSTALL REAR WIPER RUBBER


    E237506
  1. Install the 2 rear wiper rubber backing plates as shown in the illustration.

    NOTICE:
    Install the backing plates facing the correct direction.



    E237507
  1. Insert the rear wiper rubber from the front end of the rear wiper blade to the rear end through the second claw.

  1. After pushing the rear wiper rubber through the rear end claw, allow it to stick out from the rear end stopper.



    E237508
  1. Slide the rear wiper rubber through the front end claw.



4. INSTALL REAR WIPER BLADE


    E237522
  1. Engage the claw to install the rear wiper blade as shown in the illustration.

    NOTICE:
    Be careful not to damage the claw.