Home › Vehicle Interior › LIGHTING (INT) › REAR DOOR COURTESY SWITCH

REAR DOOR COURTESY SWITCH > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY
  1. Connect the connector.

  1. Using a T30 "TORX" socket wrench, install the rear door courtesy light switch assembly with the screw.

    Torque:
    6.0 N*m{ 61 kgf*cm , 53 in.*lbf }