Home › Vehicle Exterior › LIGHTING (EXT) › SIDE TURN SIGNAL LIGHT ASSEMBLY

SIDE TURN SIGNAL LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY
  1. Connect the connector.

  1. Engage the 2 claws to install the side turn signal light assembly.



2. INSTALL OUTER MIRROR COVER
  1. Engage the 5 claws to install the outer mirror cover.



    B307753
  1. Push the outside part of the outer mirror assembly and tilt it as shown in the illustration.



3. INSTALL OUTER MIRROR
  1. w/ Heater:

    1. Connect the 2 connectors and engage the guide.



    B307754
  1. Engage the 4 claws to install the outer mirror.

    NOTICE:
    Do not push in the outer mirror with excessive force. Doing so may break the mirror surface.