Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY

STEERING COLUMN ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT PRELOAD


    C248051E01
  1. Secure the steering column assembly in a vice using aluminum plates and wooden block as shown in the illustration.
    Text in Illustration 
    *1
    Aluminum Plate
    *2
    Wooden Block

    NOTICE:
    When using a vise, do not overtighten it.



    C249608E01
  1. Using SST and a torque wrench, turn the main shaft at a constant speed of approximately 1 revolution every 4 seconds and measure the preload.

    SST
    09616-00011  

    Torque:
    Preload:
    1.4 N*m{ 14 kgf*cm , 12 in.*lbf } or less

    If the preload is not as specified, replace the electric power steering column sub-assembly or power steering motor sub-assembly with a new one.



2. INSPECT STEERING LOCK OPERATION (w/o Smart Key System)
  1. Remove the key and check that the steering lock function is activated.



    C250591
  1. Insert the key, turn the ignition switch to ACC and check that the steering lock function has been deactivated.



3. INSPECT STEERING COLUMN ASSEMBLY


    C235885
  1. Check that the 2 bushings are securely installed to the steering column assembly.
    If the bushings are deformed, missing or damaged, replace the electric power steering column sub-assembly with a new one.



    C234253E02
  1. Check that the 2 capsules are securely installed to the electric power steering column sub-assembly as shown in the illustration.
    Text in Illustration 
    *1
    Capsule
    *a
    OK
    *b
    NG

    Standard:
    Capsules do not overlap the corner parts of the brackets.

    NOTICE:
    1. If the standard value is not satisfied, replace the electric power steering column sub-assembly with a new one.
    2. If the capsules have deformation, damage or misalignment, replace the electric power steering column sub-assembly with a new one.