Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM

DTC    B1695/16    Door Side Airbag Sensor LH Malfunction

for Preparation Click here


DESCRIPTION

The side collision sensor LH circuit (to determine deployment of the front seat airbag assembly LH, curtain shield airbag assembly LH and front seat outer belt assembly LH) is composed of the airbag sensor assembly, side airbag sensor assembly LH, side No. 2 airbag sensor assembly LH and door side airbag sensor LH.
The door side airbag sensor LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbag and pretensioner should be deployed.
DTC B1695/16 is stored when a malfunction is detected in the door side airbag sensor LH.

DTC No.
DTC Detection Condition
Trouble Area
B1695/16
  1. Door side airbag sensor LH malfunction
  2. Airbag sensor assembly malfunction
  1. Door side airbag sensor LH
  2. Airbag sensor assembly

WIRING DIAGRAM

Refer to DTCs B1627/82, B1628/82, B1637/82, B1638/82, B1647/82, B1697/82 and B1698/82 .

INSPECTION PROCEDURE

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

1.CHECK DOOR SIDE AIRBAG SENSOR LH


    C238395E01
  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Interchange the door side airbag sensor LH with RH and connect the connectors.

  1. Connect the cable to the negative (-) auxiliary battery terminal.

  1. Clear the DTCs stored in memory (Click here).

  1. Turn the ignition switch off.

  1. Turn the ignition switch to ON (IG), and wait for at least 60 seconds.

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC B1695/16 is output.
    A
    DTC B1690/15 is output.
    B
    DTCs B1690/15 and B1695/16 are not output.
    C

    HINT:
    Codes other than DTCs B1690/15 and B1695/16 may be output at this time, but they are not related to this check.

  1. Turn the ignition switch off.

  1. Disconnect the cable from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Return the door side airbag sensor LH and RH to their original positions and connect the connectors.
    Text in Illustration 
    *1
    Door Side Airbag Sensor RH
    *2
    Side No. 2 Airbag Sensor Assembly LH



B
REPLACE DOOR SIDE AIRBAG SENSOR LH (Click here)

C
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE AIRBAG SENSOR ASSEMBLY (Click here)