Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT PILLAR UPPER COVER

FRONT PILLAR UPPER COVER > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE FRONT PILLAR UPPER COVER SUB-ASSEMBLY


    B298020E01
  1. Apply protective tape to the vehicle body in the area around the front pillar upper cover sub-assembly.
    Text in Illustration 
    *1
    Protective Tape



    B298021
  1. Using a moulding remover, disengage the claw and 2 clips and remove the front pillar upper cover sub-assembly.