Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM

DTC    B14B2    Lost Communication with Front Panel LIN

for Preparation Click here


DESCRIPTION

The air conditioning panel (heater control switch board) communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning panel (heater control switch board) is operated.

DTC No.
DTC Detection Condition
Trouble Area
B14B2
Lost communication with the air conditioning panel (heater control switch board).
  1. Harness or connector between air conditioning panel (heater control switch board) and IG circuit
  2. Harness or connector between air conditioning panel (heater control switch board) and body ground
  3. LIN communication system
  4. Air conditioning panel (heater control switch board)
  5. Air conditioning amplifier assembly

WIRING DIAGRAM


E226613E15


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD) - IG CIRCUIT)
  1. Disconnect the G33 air conditioning panel (heater control switch board) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G33-5 (IG+) - Body ground
    Ignition switch off
    Below 1 V
    G33-5 (IG+) - Body ground
    Ignition switch ON (IG)
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD) - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G33-8 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD))
  1. Disconnect the G34 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G33-2 (LIN1) - G34-37 (LIN1)
    Always
    Below 1 Ω
    G33-2 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD)
  1. Replace the air conditioning panel (heater control switch board) (Click here).

    HINT:
    Since the air conditioning panel (heater control switch board) cannot be inspected while it is removed from the vehicle, replace the air conditioning panel (heater control switch board) with a new or known good one and check that the condition returns to normal.

OK:
Air conditioning control assembly operation returns to normal.


Result:

Result
Proceed to
OK
A
NG (When troubleshooting according to Problem Symptoms Table)
B
NG (When troubleshooting according to the DTC)
C



B
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

C
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
A

END (AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD) WAS DEFECTIVE)