Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH

HAZARD WARNING SWITCH > REMOVAL

for Preparation Click here



1. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    B301680E01
  1. Apply protective tape to the area shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape



    B301681
  1. Using a moulding remover, disengage the 8 clips and claw.

  1. Disconnect the connector and remove the center instrument cluster finish panel sub-assembly.



2. REMOVE HAZARD WARNING SIGNAL SWITCH ASSEMBLY


    E244239
  1. Disengage the 2 claws and remove the hazard warning signal switch assembly from the center instrument cluster finish panel sub-assembly.